|
Opus WCU310 wall control unit
|
|
The WCU300 is the wall control unit for the Opus 300 multi-room entertainment system and can be used as both main or sub-zone controllers. Working on the A-BUS standard, installation is extremely simple with just one Cat5 cable connection needed from WCU300 keypad to MCU300 and standard speaker cable from the keypad to loudspeakers. Remarkably, amplification for the speakers is built into the back of the WCU300 and a pre-amp output is even provided for driving external amplifiers or a powered subwoofer.The WCU300 may also be used with other A-BUS ready audio set-ups by flicking the rear-mounted switch to standard (A-BUS ), for access to all basic functions.
|
 |
|
|
 |
Full control of volume, bass, treble, balance, fader, input change. |
|
Fully A-BUS compatible. |
|
Powered by Cat5 UTP interconnect cable from the master control unit (no external power supply needed). |
|
Built-in pre-amp output for powering external amplifiers or a powered subwoofer if required. |
|
Direct connection to ceilingmounted or other speakers. |
|
Uses standard Easy-clip faceplates (full range of styles and finishes available from MK and other suppliers). |
|
Supplied complete with standard white single gang faceplate. |
|
its standard UK 47mm back box. |
|
| Dynamic Power Output: |
15 Watts rms, 4 Ohms |
| Frequency Response: |
20Hz - 20kHz |
| Volume Control Range: |
-80dB 32 steps |
| Bass Control Range: |
+/- 16dB 2dB steps |
| Treble Control Range: |
+/- 16dB 2dB steps |
| Balance Control Range: |
+/- 40dB 9 steps both ways |
| IR Pass-through: |
34 - 40kHz and 54 - 58kHz modulation |
| Power: |
powered from MSH via Cat5 or Cat6 cable |
| Size (w x h): |
84mm x 84mm - fits standard 47mm back box |
|
