The X-10 DIN rail switch is a remote controlled relay. Discretely installed at the junction box, it switches hard-wired circuits with several switches (e.g. hallway lighting). The internal relay can be tripped either by external latched or momentary action wall switches or by an X-10 controller. The AD10 responds to STANDARD X10 protocols: "All units off" from any X-10 controller set to its house code, regardless of unit code. Or alternatively, by individual unit control using "On" and "Off". When the relay is energized, the LED above the slide switch is illuminated. This unit can replace any pulse contact relay that is commonly used for multi-switched hall and entry lighting. In discrete locations, e.g. kitchen lighting, you may prefer to install the AD10 in a small sub-junction box.
- Can be remotely switched using regular, momentary timer or delay switches or via the mains using the Marmitek X-10 Commands.
- The module responds to the Marmitek X-10 Commands ‘On’, ‘Off’ and ‘All off’.
- Operation of the unit with Marmitek X-10 Commands takes place via the mains wires, which means no extra wiring is necessary.
- Momentary switches attached to the module cannot have a glow lamp in series.
- Phase and Neutral have to be available before the module can be installed.
- The module is addressed by the two dials on the front, which set the House Code and Unit Code for the module.
- Switches loads up to 3600W.
- Status indication with LED lamp.
- With the module you can control appliances and lights using the Marmitek X-10 system. Ideal for use with garden ponds, light groups, other appliances and in the office for ‘All Appliances Off’ or ‘All Lights Off’, etc.
- The module can be combined with one or more momentary switches (of any type or brand), which means the module can also be used in two way switch schemes.
- The module contains a selector switch that can be set to continuous on (1), continuous off (0) and remote control (auto).
- Can be used in combination with ‘designer’ switching material.
- The module can be mounted on the DIN Rail and built into a separate casing or into the distribution panel.
- 1 x AD10 X10 appliance module
- 1 x installation guide
| Supply voltage: | 230V +10% -15% 50 Hz |
| Electricity consumption: | < 0,02 W |
| Switching power: | 3600W/230V for resistive (ohm) load 700W/230V for inductive/capacitive load 2000W/230V for light bulbs and halogen lighting |
| Signal sensitivity: | 15 mVpp min 50 mVpp max at 120 kHz |
| Input impedance: | > 180 Ohm (L - N) at 120 kHz |
| Connection: | Connecting clamps for phase, neutral, switched phase, switch and momentary switch. |
| Ambient temperature: | - 10° C to + 50° C (operation) - 20° C to + 70° C (storage) |
| Dimensions: | 35 x 80 x 70 mm |
