Marmitek AM12W X10 appliance module with wire

The switch plug-in module is a 500W receiver unit that works as a remote controlled switch/relay. The connected load can also be switched on and off locally. The switch plug-in module can switch incandescent lamps and low energy lamps up to 500W, appliances with electric motors up to 230W or halogen floor lamps with foot dimmer up to 500 W. Just adjust the settings on the front side to the desired device address (e.g. G7) and note this address down in a list. The load connected to the switch module can still be controlled locally by its own switch, but do not forget to leave the local switch in the “ON” position, otherwise the load cannot be controlled by an X-10 controller. Switch the load off by remote control.

• With the module you can control appliances and lights using the Marmitek X-10 system. Ideal for use with garden ponds, light groups, other appliances and in the office for ‘All Appliances Off’ or ‘All Lights Off’, etc.
• Switches loads up to 3600W.
• Switch module to turn 230V appliances, halogen and tube lights, etc. on or off.
• Controllable from a distance with the Marmitek X-10 commands On/Off.
• The Module is based on a remotely controlled relay to be used in any wall socket.
• Lights or appliances can be connected to the front of the module.
• With the module you can control and dim lights using the Marmitek X-10 system.
• The module responds to the Marmitek X-10 Commands ‘On’, ‘Off’ and ‘All off’.

• 1 x AM12W X10 appliance module
• 1 x installation guide

• Download a brochure for the Marmitek AM12U plug-in X10 lamp module.
• Download an instruction manual for the Marmitek AM12U plug-in X10 lamp module.