Overview
The Dimmer plug-in module is a 300W receiver unit that works as a remote dimmer. The connected lamp can still be switched on and off locally. The dimmer function, however, is by an X-10 remote control. Just adjust the settings on the front side to the desired device address (e.g. F9) and note this address down in a list. The lamp connected to the dimmer module can still be controlled locally by its own switch, but do not forget to leave the local switch in the “ON” position, otherwise the lamp cannot be controlled by an X-10 controller.
Features
- Lights or appliances can be connected to the front of the module.
- Soft start and smooth dimming features, remembers the last dim setting.
- Can be regulated from 0% lighting to the desired dim setting.
- The module responds to the Marmitek X10 Commands ‘On’, ‘Dim, ‘Bright’, ‘All Lights On’, ‘Off’ and ‘All Off’.
What's in the box?
- 1 x LM12W X10 lamp module
- 1 x installation guide
Technical data
| Supply voltage: | 230V ±10% 50 Hz |
| Supply current: | < 20 mA capacitive |
| Making capacity: | 40W to 300W (normal light bulbs only) |
| Dimmer Speed: | 4.4s from 100% to 0% ±0.2s |
| Signal sensitivity: | 15 mVpp min 50 mVpp max at 120 kHz |
| Input impedance: | > 55 Ohm (L - N) at 120 kHz |
| X10 transmission: | 1 puls burst on 0, 60 and 120 degrees. |
| X10 key codes to respond to: | All units Off, All Lights On, On, Off, Dim, Bright. |
| When using 3-phase installation: | FD10 (three times) or CAT3000 needed |
| Fuse: | F 3A 250V 5 x 20 mm |
| Ambient temperature: | -10° C to + 50° C (operation) - 20° C to + 70° C (storage) |
| Dimensions: | 52 x 122 x 33mm (without plug) |
Downloads
Information & advice
