The Powerhorn PH7208 remote siren is a remote controlled siren with a piercing 110 decibel sound output. It receives signals over existing house wiring and responds to the “All Lights On/All Units Off” flashing sequence from the SC9000 Home Security System, or the SM10 Universal X-10 transmitter. The Powerhorn adds to any security system the ability to trigger a remote siren without the need for any special wiring. You just plug it in! Any security system which uses the SM10, to flash lights when the alarms trips, can trigger the Powerhorn.
When used with an X-10 security system or the SM10, the Powerhorn will trip a few seconds after the alarm trips and continues to sound until 4 seconds after the alarm stops or is disarmed.
You can also trip the Powerhorn from any other X-10 controller, which is useful in panic situations. It can be set to respond to any of the 256 X-10 codes available (16 House codes x 16 Unit Codes). You simply press All Lights On followed by All Units Off repeatedly or press the unit code corresponding to the number set on the PH7208 then press On, then Off repeatedly. This will trigger the Powerhorn after about two ON-OFF sequences and will continue as long as you keep repeating the sequence. The siren will shut off about 4 seconds after the last key is pressed.
- Controlled via the existing wiring
- Very loud additional siren to be mounted at a free chosen location in the house. (The SafeGuard and TotalGuard systems will control this siren through the existing power line circuit.)
| Power supply: | 230V AC 50 Hz |
| Siren: | Piëzo, 4-fold |
| Sound pressure: | 110dB(A) |
| Signal sensitivity: | 15 mVpp min, 50mVpp max at 120 kHz |
| Input impedance: | > 55 Ohm (P-N) at 120 kHz |
| Responds to X-10 key codes: | Automatically after 5x All Lights On/All Units off command or 5x ON OFF |
| Ambient temperature: | -10°C to +50°C (operation) -20°C to +70°C (storage) |
| Fixing: | Wall mounted |
| Dimensions: | 129 x 81 x 50mm |
