The TM13 responds to wireless Radio Frequency (RF) signals from any X-10 wireless remote controls or wireless wall switches. It re-transmits, over the house wiring, any signals it receives from these wireless remote controls or wall switches. A built-in appliance switched outlet responds to X-10 signals received on the power line or to RF signals received from any X-10 wireless remote controls. The TM13 responds to a serial control message in “STANDARD” X-10 format : “All units off” from any X-10 controller set to its house code regardless of unit code, or alternatively, by individual unit controller by “On” and “Off”. The TM13 can be polled for its status by the CM15Pro (two way universal computer interface) or by any controller using the Extended X-10 format.
This is the general purpose unit for the smallest to largest applications. It can be a starter kit with an X-10 RF transmitter for remotely turning ON and OFF any appliance
- Transmits signals of Marmitek remote controls to X10 signals for the mains.
- Built-in appliance module: Remote control On and Off for lights and appliances.
- Receives all 16 housecodes.
- Plug-in module with receiver for Marmitek remote controls.
- You need one TM13 per installation when you use a wireless X10 controller.
- You don’t need the TM13 if there is a Marmitek wireless alarm system or CM15Pro installed.
- 1 x TM13 X10 transceiver
- 1 x installation guide
| Supply voltage: | 230V ±10% 50 Hz |
| Power consumption: | < 1.5 Watt |
| Switching capacity: | 300W/230V for light bulbs and low-voltage halogen lamps with a 500W/230V transformer for inductive / capacitive loads 1200 W/230V for linear loads |
| Frequency: | 433.92 MHz |
| X10 transmission: | 1 pulse burst on 0˚, 60˚ and 120˚ |
| Transmission signal: | 120 kHz ± 2 kHz / 2.5 Vpk-pk |
| Signal sensitivity: | 15 mVpp min, 50 mVpp max at 120 kHz |
| X10 Key codes: | All Units Off, On, Off, Status Request |
| Input impedance: | 180 ohms (P.N) at 120 kHz |
