Features
- The MicroModule can be installed behind conventional wall switches or into wall outlets because of the extreme small size of the MicroModule (Minimum built-in depth 40 mm, advised 50 mm).
- The MicroModule is also ideal for installation into light fixtures or for use in areas with limited space such as rooms with lowered ceilings.
- No limitation in choosing brand, color or type of any wall switches and outlets.
- This module can be controlled by the switches or momentary switches connected to the module or remotely using the Marmitek X-10 (PLC) signal via the mains.
- The module responds to the following Marmitek X-10 PLC commands: On, Off and the optional Marmitek X-10 commands All Lights On/All Lights Off/All Units Off when these have been programmed.
- Both normal switches (make/break) and momentary switches can be connected to the module.
- When power is lost the module will retain the state it was in before the loss. (on/off)
- The AW12 uses 1-way X10 communications.
What's in the box?
- 1 x AW12 X10 appliance micromodule
- 1 x installation guide
Technical data
| Supply voltage: | 230V - 50 Hz |
| Supply current: | < 20 mA capacitive |
| Switching power: | 3600 W/230V for resistive (ohm) load 600 W/230V for inductive/capacitive load 2000 W/230V for light bulbs and low voltage halogen lights with transformer. |
| Minimum load: | 3W |
| Signal sensitivity: | 15 mVpp min 50 mVpp max at 120 kHz |
| Input impedance: | > 180 Ohm (L - N) at 120 kHz |
| Connections: | Wire for a standard pressure switch or momentary switch and connecting clamps for phase, neutral and switched phase. |
| Environment temperature: | -10°C to +40°C (operation) -20°C to +70°C (storage). |
| Dimensions: | 46 x 46 x 17 mm |
Downloads
Information & advice
