Features
- The MicroModule can be installed behind conventional wall switches or into wall outlets because of the extreme small size of the MicroModule (Minimum built in depth 40 mm, advised 50 mm).
- The MicroModule is also ideal for installation into light fixtures or for use in areas with limited space such as rooms with lowered ceilings.
- No limitation in choosing brand, colour or type of any wall switches and outlets.
- The LW12 can be used to switch and dim 230V light bulbs, 230V halogen lamps and low-voltage halogen lamps with transformers ranging from 60 to 250 watts/230 volts.
- This module can be activated using a momentary switch connected to it or using Marmitek X- 10 PLC signals.
- It can be operated using the following Marmitek X-10 signals: ON, Off, DIM, BRIGHT and the optional Marmitek X-10 commands All Lights On/All Lights Off/All Units Off if these are programmed.
- The unit will accept a momentary switch.
- No Neutral (blue wire) has to be connected to the LW12 MicroModule, which means it can be easily used instead of a normal switch, without additional wiring.
What's in the box?
- 1 x LW12 X10 lamp micromodule
- 1 x installation guide
Technical data
| Supply voltage: | 230V - 50 Hz |
| Supply current: | < 20 mA capacitive |
| Making capacity: | 60W/230V to 250W/230V for incandescent lamps and halogen light |
| Signal sensitivity: | 15 mVpp min 50 mVpp max at 120 kHz |
| Input impedance: | > 180 Ohm (L - N) at 120 kHz |
| X10 Key codes: | All units Off, All Lights On, On, Off, Dim, Bright, All Lights Off, extended code 1 type 3 |
| Connection: | Connecting clamps for phase, switched phase and switch (neutral not required) |
| Environment temperature: | -10°C to +40°C (operation) -20°C to +70°C (storage). |
| Dimensions: | 46 x 46 x 17 mm |
Downloads
Information & advice
